Page Comparison

...

** Please note a minimum of two MCM is required to configure the video bridge through MCS.

1. On the MCS navigate to Devices Management page. Please ensure atleast two MCM9000 devices are configured on the MCS. Please refer to Adding MCM9000 devices to MCS to configure MCM9000 devices.
   

...

1. Image Added

   
   In this example, first device MCM-9232 is used for monitoring Sources and second device MCM-9898 is used for displaying on the Output mosaic.
   

2. Please refer to Add sources to through MCS to add Sources and Configure Output Encoder on MCS to configure the Output Encoder. Also, please ensure that the Video Bridge is enabled for the right NIC in the interface configuration.
   

...

1. Image Added

2. Navigate to Sources Configuration and monitor the sources on the first device (MCM-9232).
   

...

1. Image Added

2. Navigate to Output Configuration and start the encoder on the second device (MCM-9898).
   

...

1. Image Added

2. Now goto the second device (MCM-9898) that is displaying. Here in the Sources monitored are in the Bridge as shown below.
   

...

1. Image Added

** Please note that when using light monitoring the Legacy Compressed Bridge will be in use.