MCM FW Release Notes

Version 2.0.3

** Compatibility

MCM FW 2.0.3 requires Software MCM 6.3.13 and MCS 1.2.0 and is up to be installed. Installing a different SW version may result in bricks if UEFI boot is used.

** New Features

Cisco UCS M7 support

** Fixed issues

Missing card Intel x710 from FW 2.0.2

Version 2.0.2

** Compatibility

MCM FW 2.0.2 requires Software MCM 6.3.13 and up to be installed - installing with a different SW version may result in brick if UEFI boot is used.

** New Features

Support for

Option to turn off RS-FEC in Mellanox utility (Currently supported only through shell commands.)

** Fixed issues

Address SSH Weak Key Exchange Algorithms Enabled

** Changes

Changed the Linux OS from Ubuntu to Rocky 8.

**LImitation and Notification

No logs are shown till the start of the Linux boot.

The EFI bootloader version is shown in MCM UI even if the boot is not configured to EFI mode.

**Upgrade/Downgrade:

Upgrade sequence:

Install MCM 6.3.13 and up.

Make sure that the currently running SW is the one installed - 6.3.13 and up.

Install FW 2.0.2

Downgrade sequence:

No downgrades of the MCM version to any version below 6.3.13 are supported with FW 2.0.2. If a downgrade is required, first downgrade the FW, then downgrade the MCM version.

Version 1.2.0

** New Features

Option upgrade the Mellanox driver

Version 1.1.9

** New Features

Added limited SSH access

Sudo Access to TAG terminal

** Changes

Removed 32bit support

Version 1.1.8

** New Features

Added support for NDI

Version 1.1.7

** New Features

Added support for MCR-6000

Version 1.1.6

** New Features

Updated Intel network drivers

Updated Mellanox network drivers

Support for MBC-7000

Version 1.1.5

** New Features

Updated Intel network drivers

Version 1.1.4

** New Features

Added support for QLogic FastLinQ network cards